TenTec
[Top] [All Lists]

Re: [TenTec] Jupiter Solid Aluminum Main Tuning Dial

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Jupiter Solid Aluminum Main Tuning Dial
From: "Walt Amos" <waltk8cv4612amos@att.net>
Reply-to: Walt Amos <waltk8cv4612amos@att.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 12 Apr 2010 08:36:42 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I wondered when someone would think of THAT!

Walt K8CV Royal Oak, MI.


----- Original Message ----- 
From: "David Goncalves" <davegoncalves@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, April 12, 2010 6:56 AM
Subject: Re: [TenTec] Jupiter Solid Aluminum Main Tuning Dial


> Hey Guys,
>
> Do these radios have an intermediate coupling shaft from the front panel 
> to
> the encoder, or is the knob connected right onto the encoder shaft? If so,
> any concerns about cantilevering a larger mass onto that shaft and
> potentially increasing wear on that component?
>
> David Goncalves
> W1EUJ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>