Had the same problem with my Omni-D. Do clean the crystal pins and sockets
first.
Sockets can be cleaned with a toothpick moistened with DeOxit.
Is that don't completely fix it, you can tighten up the crystal sockets by
using a toothpick (again!) to try and squeeze the two sides of the socket
cup tighter.
Removing that board should be your LAST resort.
David Goncalves
On Thu, Apr 1, 2010 at 5:03 PM, Louis Ciotti <lciotti1@gmail.com> wrote:
> So I took to cover off ans was poking around. I found that if I bush
> down on the crystal socket, the non-working bands come alive. So at
> this point I am assuming a bad solder joint at or near that point.
> Now I just have to get brave enough to get that board out. It has
> some of the band switches on it and am wondering how to get that
> "chain" off so I can remove the board to get at the bottom side.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
--
David Goncalves
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|