If "massaging" connector pins works, I'd suggest a quarter drop of
DeoxIT on each pin before the massaging to make the "massaging" more
effective and longer lasting.
73, Jerry, K0CQ
On 3/26/2010 3:48 PM, Ron Castro wrote:
> Art:
>
> The problem was originally believed to be in the "A" connector from the
> board where the RIT is to the logic board. That's a good place to start,
> but I found later that the real culprit, at least in my case, was one of the
> "board-to-board" connectors that the A connector is on. It's hard to work
> on those pins, but with a little careful nudging of the boards, you can fix
> the problem. My original post on that is below.
>
> Ron N6IE
> www.N6IE.com
>
> The connector that has been mentioned that caused the problem can be seen in
> the picture on page 4 of the Orion (565) V2 Logic Mod. It's the connector
> marked A. I checked the straightness of all of the pins and slightly bent
> the ones the original post mentioned but found the 'fix' only worked for a
> short time. I opened the radio again and found a connector on the same
> board that was not connected to a ribbon cable, but rather connected two
> boards together. I very carefully 'massaged' the boards to exercise the
> connector pins and that fixed the problem for good! It's probably been a
> year since I did that and no further problems.
>
>
>
>
>>
>> I just started having a problem with the Orion RIT/XIT. This unit is about
>> 6 yearrs old and always worked well, but it just lost its ability to use
>> the RIT/XIT.
>>
>> It seems I remember seeing this problem some time ago on the Ten Tec
>> Internet reflector, but I do not remember the fix.
>>
>> Art WA8VSJ
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|