Carl
Will all this work with N4PY version 3.09 or do I need an update ?
73
John wb4qda
----- Original Message ----
From: N4PY2 <n4py2@earthlink.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Wed, March 24, 2010 9:29:48 PM
Subject: [TenTec] Panadapter with the Tentec Omni VI
The previously announced capabilty to use a Flex panadapter with my N4PY
software also works with the TenTec Omni VI. My N4PY Icom software also
supports the Omni VI. If you add a Flex
radio to the mix (and this could even be a used SDR-1000 1 watt version for
around $200, or the new Flex-1500 for $579 from Flex Radio), the N4PY
program will allow these radios to be combined such that the Flex radio can
provide a 48 khz to 192 khz wide panadapter display. The panadapter display
will follow the Omni VI giving a highly detailed view of the area around
the frequency of the main radio. You can also click on the panadapter
display and the Omni VI will instantly tune to the frequency you have
just clicked. And the Flex radio can also serve as a sub-receiver and
provide dual receive.
There is a nice screen shot of this function at www.n4py.com on the Icom
page.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|