TenTec
[Top] [All Lists]

Re: [TenTec] Corsair II Vfo Molex Jumper

To: tentec@contesting.com
Subject: Re: [TenTec] Corsair II Vfo Molex Jumper
From: "Dr. Gerald N. Johnson" <geraldj@weather.net>
Reply-to: geraldj@weather.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 21 Mar 2010 15:43:20 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Two RCA plugs are wider than the 9 pin molex connector and good RCA 
plugs are at least as expensive as the proper molex connector which can 
be had on epay for 13 cents in lots of 100 and less than a buck at 
Mouser with the pins even cheaper both places.

73, Jerry, K0CQ

On 3/21/2010 3:14 PM, W8BVH wrote:
> gsanderlin:
> Why not just take a couple of rca plugs and wire the center pins only and
> use them. Pretty cheap.
> Best regards,
> Ralph Howes
> W8BVH
>
>
> ----- Original Message -----
> From: "gsanderlin"<gsanderlin@charter.net>
> To:<TenTec@contesting.com>
> Sent: Sunday, March 21, 2010 1:49 PM
> Subject: [TenTec] Corsair II Vfo Molex Jumper
>
>
>> Does anyone have A Molex Jumper for the Corsair II to allow it to work,
>> without the VFO connected, or know of the molex part number for the
>> housing and the pins.
>> _______________________________________________
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>