Yes, my N4PY software can link any radio supported with N4PY software to any
SDR radio that works with PowerSDR.
Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "john ferro" <foxbat426@hotmail.com>
To: <tentec@contesting.com>
Sent: Sunday, March 21, 2010 2:11 PM
Subject: [TenTec] new N4PY software question.
>
> the new n4py software says it will be able to run real time panadapter
> with many icom radios,in conjunction with an sdr-1000 or new flex 1500. my
> question is would the new software support an icom 746 real time
> panadapter with an SDR-IQ receiver?? i hope nate can answer directly.
>
> thx and 73, john
>
> _________________________________________________________________
> Hotmail: Trusted email with powerful SPAM protection.
> http://clk.atdmt.com/GBL/go/210850553/direct/01/
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|