Dave,
I had something similar with my Orion 1.
I was picking up an AM broadcast station over the Orion speaker when I
transmitted as well as some feedback.
I found out that it was caused by a cable adaptor that was plugged into one
of the jacks on the back of the Orion....a 1/8" mono to RCA jack converter
plug.
I clipped the 1/8" jack off the cable, soldered on an RCA jack and the
problem disappeared.
gl,
Rolf NR0T
Date: Tue, 16 Mar 2010 02:58:15 +0000 (UTC)
From: davkozy@comcast.net
Subject: [TenTec] Omni VII Feed Back
To: "Ten-Tec, Discussion" <tentec@contesting.com>
Message-ID:
<
292080028.15241881268708295310.JavaMail.root@sz0045a.emeryville.ca.mail.comcast.net
>
Content-Type: text/plain; charset=utf-8
Hi all,
???? I have had the Omni VII since right after Dayton 2009.? Works great!?
However, I ran into a problem last night. When I tried to transmit ( SSB ) I
get an extremly loud feed back shriek through the speaker!? It almost seems
as thought the radio is transmitting at the same time it's receiving. It
just started doing it as I had just finished a QSO not more that 10 minutes
prior to this problem. I did not change anything from the last QSO to the
next accept for the frequency.
??? Has anyone else encountered this problem?? Does anyone have any
suggestions?
Your comments are most welcomed.
Dave,? KB9EPL
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|