Hello...
I feel rather foolish, but... I was cleaning up connectors in my Omni VI and
I've got two spots that I'm not sure how they go... I wasn't paying attention
when I pulled them out. In both cases I have a 3-pin connector with four pins
to choose from; both on the logic board.
1. At the front, toward the center of the rig: #99 and #80 -- There's an
extra pin there... do I leave an empty one all the way to the right, the left,
or in between the two connectors (looking from the front of the rig)?
2. Back behind that a little is connector # 41. Directly behind it is #34, a
2-pin connector. Do I skip a pin between #34 and #41, or does #41 go right
next to #34.
Anybody know without tearing your rig apart?
Foolishly yours,
Jim, AF3Z
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|