I would call the shop they are very helpful . I am sure they will work with
you to find the right answer . all the best 73 de kb2huk John
----- Original Message -----
From: "Richards" <jruing@ameritech.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, March 11, 2010 11:25 PM
Subject: Re: [TenTec] power supply hum
> Oh... I see.
>
> Thank you for the courtesy of such a prompt reply.
>
> I, too, have been pleased with its performance. The only
> negative is that I must give up computer control of the rig if
> I want to use the serial port on the rig for communicating
> with the tuner. I have not yet figured out how to use a
> serial Y-adapter, but supposedly it will work.
>
> Thanks, again.
>
> ================= Richards - K8JHR ====================
>
>
>
> On 3/11/2010 11:12 PM, John Molenda wrote:
>
> spoke with Plaster several times and they said they
> will not be able to get the Orion II to work in this manor
> because of the way the software is written .
>
> ===========================================================
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|