Stephen,
Thank you for the tip, as much as I looked around the TenTec site I did not
come to that section - now it is in may Radio Favorites tab.
I was probably wrong the other day on computer control of the Delta II and
Argo, but I can't figure that out and have not seen software for the serial
port -
Kris (KA2OIG)
Merschrod
123 Warren Road
Ithaca, NY 14850
www.merschrod.net
----- Original Message -----
From: "Stephen Cannon" <sugar_bears_home@yahoo.com>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Tuesday, January 19, 2010 8:55 AM
Subject: Re: [TenTec] Rig Control
> Kris,
> Many of the obsolete Ten Tec Manuals can be downloaded from Ten Tec
> including the 535/536 Manual by going to
> http://radio.tentec.com/downloads/
> then choose the Obsolete Manual tab. The 535/536 is the first one on the
> list.
>
> Stephen AD7TD
> -----Original Message-----
> From: Kris Merschrod
>
> Steve,
>
> (It is lamentable that the manuals for all Tentec rigs are not on a
> website
> to make reference to.) There are two 8-pin (DIN-type) jacks on the rear
> of
> the rigs. 1) is for linking to a tuner and gives out the band that the
> rig
> is set to. 2) is both an audio input and output, and keying control for
> amp-to-rig. The psk-type linking is done through this jack. There is
> recvr
> muting on one pin, etc.
>
> If anyone needs the exact tect I'll be happy to type out the pin
> descriptions from page 2-10 of the 535/536 manual.
>
> Kris (KA2OIG)
> Merschrod
> 123 Warren Road
> Ithaca, NY 14850
> www.merschrod.net
> ----- Original Message -----
> From: "Steve Berg" <wa9jml@tbc.net>
> To: "N4PY2"
>
>> Carl,
>>
>> What sort of rig control was present in the Delta II and Argonaut II
>> radios. There is a jack on the back panel and as I remember Ten Tec
>> made some sort of digital adapter for these radios.
>>
>> 73,
>>
>> Steve WA9JML
>>
>> N4PY2 wrote:
>>> The Paragon was the first Tentec radio with computer control. The Omni
>>> V
>>> was the first Omni series with computer control.
>>>
>>> Carl Moreschi N4PY
>>> 121 Little Bell Drive
>>> Hays, NC 28635
>>> www.n4py.com
>>>
>>>
>>> ----- Original Message -----
>>> From: "Bob AD5VJ"
>>>>>
>>>> What model does tentec start with using computer control?
>>>>
>>>> Bob AD5VJ
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|