Yes, internal keyer only. I just verified that. Funny things happen
if you record with SP=off (int. keyer disabled).
73 & happy festivities!
Martin AA6E
On Thu, Dec 24, 2009 at 10:48 AM, Pumbaa <pinkertontommrs@bellsouth.net> wrote:
> It has been a bit since I read the owner's manual of my Orion 2. However, I
> believe it said that to record I must use the Ten Tec internal keyer. It
> works fine using the internal keyer and an iambic paddle.
>
> Tom AG8K
>
> ----- Original Message -----
> From: "John Chance-Read" <johnchanceread@yahoo.co.uk>
> To: <tentec@contesting.com>
> Sent: Thursday, December 24, 2009 9:10 AM
> Subject: [TenTec] Orion 1 - CW Memory
>
>
> I'm new to my Orion 1 and have just tried memorizing a CW call into SEND 1.
> The memory indicates the number of characters memorized, which I then
> RECORD. I then STOP, but when I press PLAY to check it nothing happens . I
> then Exit and as if normally operating I press SEND 1 - nothing happens. I
> am using a straight keyer - is this the problem ?.
> Help appreciated
> John G4BOU
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
--
Dr. Martin S. Ewing, AA6E
Member IEEE, URSI, AAS, ARRL
Branford, Connecticut
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|