TenTec
[Top] [All Lists]

Re: [TenTec] Updated "FIX IT" list for Orion II v. 2.041XL

To: ronc@sonic.net, tentec@contesting.com
Subject: Re: [TenTec] Updated "FIX IT" list for Orion II v. 2.041XL
From: Rsoifer@aol.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 22 Nov 2009 08:43:53 EST
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Hi Ron,
 
To these I would add:
 
1.  Variable or selectable bandwidth on sweep/waterfall  (i.e., not always 
72 kHz)
 
2.  Variable sensitivity on waterfall display (it's presently  controlled 
by the RF gain setting)
 
73 Ray W2RS
 
 
In a message dated 11/22/2009 12:40:18 A.M. GMT Standard Time,  
ronc@sonic.net writes:

I  avoided getting into the recent food-fight on this reflector about  
problems with the Orion and Orion II firmware since the volley seemed more  
emotional than objective.  Those of you who know me or have read my  posts 
in 
the past know that I am neither a TT cheerleader nor basher...I  report, 
you 
decide.

Now that the dust has settled and most of the  blood has dried, I thought 
it 
would be good to update the v 2.041XL Fix  List on my website.  It can be 
found  at:

http://n6ie.com/Wish%20List2.htm

The list below is only  about the 2.041XL update for the Orion II.  On the 
web link, you'll  find the cumulative wish-list as well.  Here is a summery 
of what I  hope TT is working on for the next 'non-beta' release:

1.  Red Screen problem.  Sweep goes to weird red lines and/or  background. 
Big signals were initially thought to be problem, but tests of  up to 0 dBm 
could not recreate the problem.  This seems to happen  only rarely but it 
is 
a PITA.
2. Spot level is many dB  below S-Tone level.  They should be about the 
same.  They  increased the side tone volume, but forgot about the spot 
tone, 
which  adjusted with the same control.
3. S-Meter and Sweep do not  change while tuning main dial. This bugs me 
more than I thought it  would!
4. Popping on AF AGC (setting AGC constants very slow  mitigates but does 
not eliminate problem)
5. Low level on  AF AGC relative to RF AGC of 10 to 20 dB
6. Reports of "noise  crash" on AF AGC when Notch on AN pressed. (Many 
people saw this  initially, but it seems to have gone away on its own.go  
figure!)
7. NR in AF AGC: sounds like it needs more  level.

Ron   N6IE
www.N6IE.com

_______________________________________________
TenTec  mailing  list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>