TenTec
[Top] [All Lists]

Re: [TenTec] 509 Update

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] 509 Update
From: "Gary Harmon" <gharmon@idworld.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 16 Nov 2009 08:46:07 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Thanks Ed.  I appreciate the encouragement.

Talked to Ten-Tec and the parts I need are available (dial cord assy,
accessory plug, AF Gain/ON-OFF switch and small PCB screws).  All that I
need is a matching panel paint.  I'll inform the list of any success.

73,

Gary H. Harmon, Jr. - K5JWK
6003 Archwood
San Antonio, TX 78239-1504
210.657.1549h
210.884.6926c

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Ed - K9EW
Sent: Monday, November 16, 2009 8:20 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] 509 Update

Hi Gary,

This sounds like a *real* project radio.  But all the 509 owners on the list
will be interested in your progress, so check in whenever you have an
update.

73/73,
ed - k9ew
www.k9ew.us

On Mon, Nov 16, 2009 at 6:01 AM, Gary Harmon <gharmon@idworld.net> wrote:
> The filter jammed inside this 509 was a MFJ CW-2 unit.  It was wired 
> into the accessory socket in place of the jumper between pins 4 and 5.  
> Two switches were mangled into the front panel.  The whole setup could 
> have been mounted in a little box and wires run to the accessory and 
> 12v sockets ad eliminated the front panel damage.  The AGC mod was a 
> switch added to the back panel with a 220 mfd cap.  C16 (125 mfd) cap 
> was raised off the board and wired to the switch.  Seems like AGC was 
> obtained by switching between the two caps.  Both mods have been 
> removed and five holes plugged with J-B Weld.  ON-OFF switch is in
constant ON mode.
>
> Smoke residue has been removed.  Need dial cord assembly, accessory 
> plug, and volume control/switch.  Will see what Ten-Tec has to offer this
morning.
> Hopefully the model store will have some similar paint for the panel
plugs.
>
> Neat little radio.
>
> Vr,
>
> Gary H. Harmon, Jr. - K5JWK
> 6003 Archwood
> San Antonio, TX 78239-1504
> 210.657.1549h
> 210.884.6926c
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>