Hi Dennis,
Is the meter lamp on when the Omni V POWER switch is off? Probably
not, and if this is the case, the meter lamp being on when the Omni V
POWER switch is on should indicate that+13.5v is being fed to all
circuits from the DC Power board. I assume that you have tried pushing
the RESET button.
73, Tony W1OT
On 11/2/09, Denton <denton@oregontrail.net> wrote:
> Wiggle the power supply's connector on the back of the Omni....sounds like
> something in the power supply chain.
> ----- Original Message -----
> From: "Dennis Kippa" <kw5g@yahoo.com>
> To: <TenTec@contesting.com>
> Sent: Sunday, November 01, 2009 5:54 PM
> Subject: [TenTec] Omni V problem
>
>
>>I was tuning up on 75 meters tonite when the Omni V shut down suddenly. SWR
>>
>>was below 1.5 to one. I reset the power supply but only the light on the
>>meter came back on. No receive and the freq will not display. Any ideas
>>where to start looking???
>>
>> Dennis n5dpk
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|