TenTec
[Top] [All Lists]

Re: [TenTec] Omni D Strange Behavior

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni D Strange Behavior
From: Stuart Rohre <rohre@arlut.utexas.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 27 Oct 2009 17:41:28 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Omni D problem.  Check the solder joints for the display board.  Sounds 
like a cold joint somewhere there.  Use a high power magnifier and a 
strong light.  If in doubt touch up all less than perfect looking solder 
joints.

-Stuart Rohre
K5KVH

John Peters wrote:
> Hi MIKE
>       I have had a trouble with the digital display on my OMNI D.      
> the display is unstable for a fer minutes
> and then it is o kay---   for a short while    then goes showing all  
> numbers (unstable) again.  then
> a few minutes it goes okay    with a little tapping at times....     
> Then runs o kay the rest of the day....
>       do you have anything for a fix?????
>           hope so    ??
>                thanks     John    K2kot        c ya
>
> On Oct 27, 2009, at 11:16 AM, Mike Bryce wrote:
>
>   
>> every now and then, especially when it's kind of cool in my shack,
>> when I turn the omni VII on, there's no display.
>>
>> I do get the leds by the switches to light
>>
>> I just leave it on and within a few minutes, it decides to light up.
>>
>> cycling power does nothing to help
>>
>> However, if the room is warm, then I've never had the trouble. It
>> seems as though the cool temperatures is preventing something from
>> firing the display backlight
>>
>> mike
>>
>> Mike, WB8VGE
>> SunLight Energy Systems
>> The Heathkit Shop
>> http://www.theheathkitshop.com/
>>
>>
>>
>> On Oct 27, 2009, at 5:50 AM, Hulett, Russell wrote:
>>
>> Yesterday, turned on the Omni VII and nothing happened. No lights or
>> anything, like power disconnected. The fuse was ok, voltage on the
>> supply connector checked fine.  After several tries, the display
>> backlight came on but the radio didn't "boot".  Cycling the power
>> switch once more caused the radio to startup normally.  All memory
>> intact, radio works normally.  Anyone else experienced anything like
>> this?
>>
>> 73, Curt KB5JO
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>     
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>   
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>