John,
Having a omni VI-3, I've read where there is a pinout error in the manual.
Assuming, the VI+ manual kept the error alive, I think there are two pins
that need to be reversed. As I recall, that came over this reflector. This
was an issue in making up a db25 to a db9 serial cable, per the manual. You
may want to search the archives for that discussion if no one jumps in here.
Or I can find the info for you. I remember making one up with the reversed
pins and it worked fine. Nada without.
David
----- Original Message -----
From: "John Hensley" <w5jv@hotmail.com>
To: <tentec@mailman.qth.net>; <tentec@contesting.com>
Sent: Tuesday, October 06, 2009 10:32 AM
Subject: [TenTec] Need 301R factory sheet or sheets
>
> If anyone has the 301R factory information sheet or sheets, please email
> same to me or QSL for my address. I found someunofficial information but
> would feel better seeing the TenTecdiagram & pin-out in terms of making up
> a new DB-25 cable.
> Are there any caveats when using other functions on theOMNI VI+'s DB-25
> socket?
> TIA, John W5JV
> _________________________________________________________________
> Hotmail: Trusted email with powerful SPAM protection.
> http://clk.atdmt.com/GBL/go/177141665/direct/01/
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|