Andrew,
Understood!
If I recall correctly, the pin on the Corsair II rebuild kit was a very
small "roll pin". If yours is the same, gripping it with pliers and
rotating it as you push it in may help; but you need to rotate it the
correct way so that pin diameter decreases rather than increases .... if
that makes sense :)
Steve G3TXQ
Andrew Moore wrote:
> Steve - it appears to be a pin that's used only for analog rigs with a dial
> cord.
>
> This makes sense, as the instructions say:
>
> 29. On analog rigs -- turn tuning shaft fully CCW. Install pin in shaft and
> reinstall dial cord.
>
> I think I just need to persuade the pin to go about 1 mm further and it
> should be strong enough for an anchor point for the dial cord. I expect any
> questions will be answered by the dial cord kit instructions -- that project
> will start as soon as I button up the PTO.
>
> Thanks,
> --Andre
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|