When first installing this chip, an initialization procedure
must first be run. With the new chip installed, do the following:
1) Power on the Omni V
2) Press the reset button on the right hand side of the Omni V
3) Power off the Omni V
Now clear all memories and set the band registers to the
default values:
1) Power off the Omni V.9
2) Press and hold the clr/clk key.
3) Power on while the clr/clk key is pressed.
4) Release the clr/clk key after 1 second.
The Omni V.92 should now be ready for use.
Remember, the keys on the keypad now have different assignments and really
need to be relabelled. See the omniv92.txt file I sent you.
Carl Moreschi N4PY
121 Little Bell Mountain Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: <Smileywb4@aol.com>
To: <tentec@contesting.com>
Sent: Tuesday, September 08, 2009 3:08 AM
Subject: [TenTec] omni v chip upgrade
> Placed V.92 Chip in my rig and tried all resets but only direct entry
> feature works.The frequency seems to default to somewhere in 20 meter
> band. I
> desire to have vfo spotting function after using zero beat function on
> omni
> C for over 20 years. Any ideas. Thanks and 73. Smiley wb4edb
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|