What you see is normal for 2.041XT which is a beta firmware load. You'll
also notice that when you tune, the S-meter stays exactly where it was when
you started tuning until you stop, so if you're listening to an S9+20
signal, when you start tuning the meter will stay at S9+20 until you stop
turning the dial.
Those are about the only two major irritants in the latest
version...hopefully, there will be an update.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "John Molenda" <brazos@rochester.rr.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, September 06, 2009 4:32 PM
Subject: [TenTec] software up grade
> Hello all , I have a question . I downloaded version 2.041xt with dsp
> 2.08B80 on my Orion II soon after it came out . Lately I will get the red
> line cross the sweep screen from right to left and right after the entire
> sweep screen will go red showing the signal peaks in white , it will stay
> like that for a few minutes and then go away only to come back a short
> time later . I am using the display color 4 . A regular reset does not
> help you should also know that the redline moving from right to left would
> happen now and then ever since I downloaded the software . Has this
> problem been take care of , did I miss something even more probable did I
> screw something up ? any info will of course be appreciated. John kb2huk
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|