On Sep 6, 2009, at 10:59 PM, Jerry Kitterman wrote:
> I just received a new dc connector for the back of the Omni. Now,
> just how do I go about removing the old one and installing the new?
> The leads are so short you could never cut them. Can a hot soldering
> iron heat the tips of the connector pins and melt the solder that
> way? Of course I know it would make a mess of the plastic connector
> but it's trash anyway. Also, it would be very hard to cut through
> the connector since it seems to be pretty tough. Inquiring minds
> need to know!! Tnx/73
If it's a MOLEX connector, you can use a small screwdriver to bend
the tab that holds them in so they pop out the other end. You go in
from the "front" and they pop out the back. You can practice on the
disk drive connectors on an old PC power supply. At one time Radio
Shack sold a special tool for it, you put it around the pin and pushed
the plunger.
Maybe someone still sells them.
Geoff.
--
geoffrey mendelson N3OWJ/4X1GM
Jerusalem Israel geoffreymendelson@gmail.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|