Hi Ray,
I've not had that problem with my Argonaut V but I did improve the
calibration on my Pegasus a while back. I suspect the situation is very
similar.
It sounds like the TCXO is off a little bit. In the case of my Pegasus, I
tweaked the TCXO trimmer and put the radio right on frequency. In fact,
this morning I checked it as I do from time to time and it is still within 2 hz
at
10 Mhz (WWV). Not too bad. The Argonaut should be able to get
somewhere in that range too I would think.
Hmmm.................? Maybe I'll check out the Argonaut just for the fun of
it.
:-)
73,
-Lee-
WA3FIY
On 15 Aug 2009 at 11:07, Rsoifer@aol.com wrote:
> Hi,
>
> My Argo V (with TCXO) reads 100 Hz low, i.e. 10 MHz WWV zero-beats at
> a reading of 9999.900. It isn't a warm-up drift problem as the
> reading is quite stable with time, well within the spec of 3 ppm
> drift. Performing a master reset per the manual had no effect on the
> problem.
>
> Has anyone else encountered something like this?
>
> 73,
>
> Ray W2RS
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|