I may be wrong, but I think this is to set the Orion's frequency dead on the
mark. It's either that or the hardware mic gain control.
Carl Moreschi N4PY
121 Little Bell Mountain Drive
Hays, NC 28635
www.n4py.com
----- Original Message -----
From: "Rick W" <ve7tk@yahoo.ca>
To: "Ten-Tec Reflector" <tentec@contesting.com>
Sent: Thursday, August 06, 2009 4:29 PM
Subject: [TenTec] Orion senior moment??
There's an access hole on the bottom of the Orion about 1 inch (2.5 cm)
behind the USER2 button. It provides access to a trim pot or variable
capacitor.
What does this adjust?
Thanks.
73,
Rick
VE7TK
Website: http://www3.telus.net/ve7tk
__________________________________________________________________
Ask a question on any topic and get answers from real people. Go to Yahoo!
Answers and share what you know at http://ca.answers.yahoo.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|