Hi!
Is the Pass-band tuning operating normally?
I had some flaky problems that were caused by dirty connectors
between boards & controls (display and PBT in particular). Someone
on the list recommended "exercising" all the connectors. So, I did
that and tried to clean the contacts, at the same time. It takes
some patience and a gentle touch, I think... but a general clean up
of the connectors may be worth a try... even as preventive
maintenance if they haven't been done in a while.
All that is imho. :-)
Jim, AF3Z
At 6/27/2009 12:17 AM, you wrote:
>My receiver emits a wind tunnel like rushing sound and tone on all
>frequencies when rf gain is at or near max.? it just started doing
>this after working flawlessly.? any suggestions would be appreciated.
>73 de John, k5see
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|