Thanks, Perry. Everything works just as you said.
w8au@sssnet.com wrote:
> At 01:36 PM 6/16/2009, w8au@sssnet.com wrote:
>> At 12:45 PM 6/16/2009, Tom, N0JMY wrote:
>>>> My question is basically where/how (in physical terms) do you measure
>>>> this current? The final amp is a sealed unit for all practical
>>>> purposes.
>> The 12V buss enters the PA section through a feed-thru insulator.
>> Usually a RED insulated wire.
>> Just unsolder this lead and insert the VOM.
>
> Forgot to add: if bias pot controls the final amp and you
> want to eliminate the additional reading of the driver,
> just crank the pot to full cutoff, measure the current
> and then adjust the pot for an additional 6 ma.
>
> Perry
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|