Yes, the diodes are used to program counter presets for the various
bands. Also, I had a leaky bypass capacitor on the counter board that
caused erroneous readings.
73,
Bob WB2VUF
Dr. Gerald N. Johnson wrote:
> -------- Forwarded Message --------
>> From: snowy.howell@openreach.co.uk
>> To: geraldj@storm.weather.net
>> Cc: snowy.howell@btinternet.com
>> Subject: Ten Tec archives
>> Date: Thu, 11 Jun 2009 11:47:28 +0100
>>
>>
>> Good morning Doc from the UK.
>>
>> I have a request for help/advice that I would like to post onto the
>> Ten Tec archives but cant seem to post it.
>>
>> If tell you my tale of woe can you be so kind as to post it for me or
>> advise how I can do it for myself.
>>
>> I have a Corsair 1 that now has some erroneous frequency readings on
>> 10, 17, 21.
>>
>> When I purchased it there were no readings at all (all 'E's), the
>> circuit diagram and component layout pictures in the manual are
>> different to what is fitted to the radio.
>>
>>
>> I purchased at great expense the 'prom' for the counter display, that
>> made no difference.
>>
>> I then replaced all of the 'ic,s' in the counter and it started
>> working on some bands.
>>
>> I subsequently found out from the seller that he had changed all the
>> diodes on the counter board, on checking the circuit diagram some of
>> the diodes look to be the wrong way round, maybe this is what is
>> causing the erroneous readings!!
>
> I have only Corsair II data and there are no diodes on the counter
> board, but a gang of diodes could have been used in the Corsair to
> convert band data to binary for the processor. Diodes backwards will
> upset that logic.
>> My question is 'Has anybody got a digital picture or can take one of
>> the diodes so I can compare their picture to my PCB'.
>>
>> Is the frequency display the same as the Corsair 2, I have 1 of those
>> radios as well that I can refer to.
>
> Apparently not since there are no diodes on the 2's counter board. There
> is a single wire band input but I've not been able to trace it. Probably
> the BFO, and injection frequency inputs are enough to count the band
> correctly.
>> If you please pick out the relevant points and post that for me
>> please.
>>
>> Regards
>>
>> 73
>>
>> G0HZE
>>
>> Snowy Howell BCRE25
>>
>> BT OPENREACH
>>
>>
>>
>> Tel (01733) 816251
>> Fax (01733) 331886
>> E mail snowy.howell@openreach.co.uk
>>
> 73, Jerry, K0CQ
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|