| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] TT and the rest of us... |
| From: | Steve Hunt <steve@karinya.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 21 May 2009 19:11:29 +0100 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I'll say it again folks: these are misleading labels! A load of 2+j10 needs the **same** configuration as a load of 1000+j1000: shunt C across the load. A load of 2+j9 needs the **same** configuration as a load of 49-j1000: shunt C across the source. Where's the sense in distinguishing these configurations as "High Impedance" and "Low Impedance"? Steve G3TXQ N4PY2 wrote: > The tentec 538 tuner is a reversible L. That means it has 2 configurations > for the L. One for high impedance and one for low impedance. > _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Re(Ten TEC) Palstar Tuner, Darrell Bellerive |
|---|---|
| Next by Date: | Re: [TenTec] Palstar tuner, Steve Hunt |
| Previous by Thread: | Re: [TenTec] TT and the rest of us..., N4PY2 |
| Next by Thread: | Re: [TenTec] TT and the rest of us..., Gary Hoffman |
| Indexes: | [Date] [Thread] [Top] [All Lists] |