If I may jump in with a question. I have a jupiter but my Drake 2B rcvr
might need this, after I recap it.
I have a MFJ 259B antenna tester, which will work as a frequency counter
that does resolve to 1 hz. Do I need to build a probe with a clip on
the outboard end, or is placing my antenna close to the circuit
sufficient? There is a max of 5V Peak-to-peak on the input of the counter
John Graves
WA1JG
jh.graves@verizon.net
Ken Brown wrote:
>> he tried to set up the bfo adj's ,but didn't have test gear up to the task.
>>
>>
> Test gear needed to adjust BFO crystal oscillator frequencies in Omni VI
> (and I am guessing also Omni V)
>
> Method 1, simplest:
>
> 1 eA frequency counter with resolution and accuracy down to about 10 Hz
> at 9 MHz.
> 1 eA high impedance probe
> 1 eA insulated trimmer capacitor adjustment tool
>
> Method 2, if you don't have access to the frequency counter, but more
> difficult:
>
> 1 eA general coverage receiver that can listen to 9.000 MHz and 9.003
> MHz. Doesn't even need to have a BFO.
> 1 eA 100 kHz crystal calibrator that will generate harmonics up to 9 or
> 10 MHz (10 MHz so you can calibrate the calibrator against 10 MHz WWV)
> 1 eA computer with sound card and program that can accurately tell you
> the beat frequency between 9.003 MHz and 90th harmonic of 100 kHz.
> 1 eA high impedance probe
> 1 eA insulated trimmer capacitor adjustment tool
>
> You can build the probe from a small capacitor and a resistor, or you
> may even get enough signal with a little pick up loop on the end of a
> piece of coax. Even a plain screwdriver will do, but will require more
> patience and finesse.
>
> DE N6KB
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 8.5.285 / Virus Database: 270.11.31/2028 - Release Date: 03/28/09
> 07:16:00
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|