Bob
?I was reading the back part of the manual I think you most likely found the
problem. Ten Tec gear is new to me and it takes a while to read and understand
just how they do things and way. I will borrow the necessary gear and go thru
the rig,hope that will cure the problem,think it will.
thanks
dale wt4t
-----Original Message-----
From: Bob McGraw - K4TAX <RMcGraw@Blomand.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Fri, 27 Mar 2009 8:49 pm
Subject: Re: [TenTec] poor harsh audio on OMNI-V
Since the IF and filters are the same for all bands, there is no reason for
160M and 80M to sound any different than any other band other than the fact
on 160M and 80M you are using LSB (40M too) and on other bands USB. There's
different BFO's for LSB and USB. Now as to no bottom end on the audio,
likely the BFO frequency is incorrect. Sounds like a proper alignment with
a good frequency counter is needed. Those oscillators do have interaction
between CW, USB, LSB and FSK and require adjustment to 1 Hz or better. The
procedure is in the manual and must be followed precisely in sequence for
proper results.
Quick and easy test. Tune in a SW station on the upper end of 40M using
LSB. Then without changing anything, switch to USB. If the sound changes
the BFO's need alignment.
73
Bob, K4TAX
----- Original Message -----
From: <yash@aol.com>
To: <tentec@contesting.com>
Sent: Friday, March 27, 2009 8:29 PM
Subject: [TenTec] poor harsh audio on OMNI-V
> Hi
> ???? Just sold my Corsair II line.
> Always enjoyed the audio quality,very easy to listen to. Bought a
> really nice OMNI-V ,with the 9.2 chip and ALL the filters. The
> audio...on a separate speaker... sounds Tinny and harsh. Not as bad on
> 160 and 80? ,but up the bands, has that tinny,harsh sound. 160 and 80
> are ...ok but..no where near the quality of the corsair II. the 2.4khz
> filter sounds closed in,constricted, ? and 1.8 even worse, hard to
> copy. Iam new to Ten Tec and the ONMI-V soI haven't been able to
> compare with another omni-V rig.
>
> ?? Seems like there is no bottom end in the receive audio,like a filter
> was cutting at 200-300hz. I noticed in the reviews of the rig ,all the
> comments on audio seemed very good.Anybody have any Ideas where to
> look? or some thoughts on the problem.
>
> thanks for any help on this.
>
> dale wt4t
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|