What's your price for the Model 223A noise blanker for the Argosy?
I'm interested in buying.
73, Winston K4CWQ -------------- Original message from "david"
<n4xce@bellsouth.net>: --------------
> Heres the chance to get a bunch of Tentec boards and parts that are no
> longer available ,some are new old stock and some are used , but all are
> good and come with documentation.They are for the Argosy ,Argosy II Triton
> IV origional Omni A and D series, Century 21 and 22 , Delta II and Argonaut
> II ,Scout and Argonaut V,s
> Three matched matched sets (of four ) HP Schottky diodes to replace the
> origional diodes in the receiver mixer on the Argosy,s This greatly improves
> the dynamic range and noise floor,plus an KVG monolithic filter that
> replaces the BFO coupling cap that really makes a difference.I have a copy
> of the artical from Ham Radio novenber 1968 with them.
> 6- 10k pots with push pull on off switch ,These are origional (but used
> pulls) from Triton IV,s and origional Omni A,D and C series , 6 - origional
> (used pulls) 10 k single pots for Triton IV,s Omni,s ect , 30- .003uf and
> 16- .002uf low noise replacement caps for the audio filter and audio
> coupling for the Argosy,s , Triton IV,s Omni,s Century 21 and 22,s .2- 10
> meter crystals for the Triton IV or Century 21, 1- pair of front folding
> legs for the Triton IV or Century 21, 2-PTO rebuilding Kits for the
> Argonaut,s Triton IV,s or Omni A,D series , Dacron and elastic dial cord and
> several red pointers for the Analog Argonaut , Triton IV or Omni A,s , 4 -
> dual gate Mosfets for the receiver preamp for the Triton IV and OmniA, D
> series , 2 - 20 meter and two 40 meter toriod coils for the Triton IV or
> Century 21 , 1 pair origional Proms for the Pegasus , 2 - TR ( reed relay)
> relays for the Triton IV and Omni A,D,s , 1- model 223 Noise blanker for the
> eairly Argosy (prior to SN 825) 1- model 223A noise blanker for the later
> model Argosy,s , 1 model 249 noise blanker for the Triton IV .I also have
> documentation on using the 249 and 223 NB,s in place of each other and
> installing them in the Argonaut series ,An un opened Embeded Research model
> AF-224 audio CW filter board kit for the Argosy,s . a stock (pull) 4 pole 9
> mhz SSB crystal filter from the Argonaut series , 1-12 volt 5 amp DC
> circuit breaker for the Century 22 , Century 21 and Argonaut II , 1 12 volt
> 18 amp circuit breaker for the Triton IV or Omni D series with alumnium
> mounting brackets , model 1150 over voltage crow bar protection modual
> (plugs in line with the power cable) for the eairly Triton IV and Omni D
> series , 1-five position 2 pole replacement waffer for the rotary band
> switch on Centiry 21,s and Triton IV,s , 6 -(4 new , 2 used) 2 pin molex
> power cables for the Delta II ,Scout and Argonaut V,s ,6- ( 4 new and 2
> used ) 2 pin molex power plugs for the Delta II , Scout and Argonaut V,s and
> a non working model 936 22 amp power supply for the Delta II,The
> transformer is good , the regulator board has damage and a 0 to 30 amp
> pannel meter has been professonally mounted on the fornt .If I find any more
> parts I will throw them in too,I also will include copies of quite a bit of
> modification information on the Century 21 and 22,s , Argonauts , Argosy,s
> Triton IV,s Omni A and D,s and the Delta II,s .After many years of
> serviceing and modifing Tentec gear I,m getting out of working on and
> modifing radios.I,m open to offers over $200 for everything.Please contact
> me , David N4XCE at 1-251-478-8823 or email me direct at n4xce@bellsouth.net
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|