Hi Kim,
I just checked on this and found the same behavior as you describe.
Lin
WB1AIW
-----Original Message-----
>From: Kim Elmore <cw_de_n5op@sbcglobal.net>
>Sent: Mar 3, 2009 10:32 PM
>To: Tentec Contesting List <tentec@contesting.com>
>Subject: [TenTec] New Firmware
>
>Concerning RF AGC behavior in FSK mode:
>
>I just performed the "battery fail" master reset to insure that I had
>a clean slate and I still see the atypical behavior of the S-meter
>with RF AGC in FSK mode. It's as if the AGC is preset to a "medium"
>or "fast" and none of the setting I enter (including hang time) are
>effective. However, when I am in the menu, the settings do seem to
>have a effect. Once I exit the menu, however, my settings and the
>setting of the AGC are immaterial.
>
>Can anyone else verify this?
>
>Kim Elmore, N5OP
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|