2.041 Users,
Set O2 for AF AGC.
Then try setting the AGC to SLOW or PROG, then go into the RX menu and turn the
decay rate to less 6dB/s.
I found that severe distortion occurs.
Further, a decay rate of 6 and 7 dB/s causes the decay rate to go to 0; it
won't ever decay.
Does this occur when you folks try it?
Lin
WB1AIW
-----Original Message-----
>From: John Sheeley <wb4qda@yahoo.com>
>Sent: Feb 27, 2009 3:32 PM
>To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
>Subject: Re: [TenTec] 041 firmware rev
>
>Dennis
>
>Same here .I just turn the scope off and then back on. it corrects it.I sure
>am liking what I see so far in this update The AF agc setting just does away
>with most the noise on a very noisy 75 meter phone band today. Its like a
>whole new Radio .
>More fun fron Tentec
>73
>John wb4qda
>
>
>
>----- Original Message ----
>From: Dennis Duffin <duffind@verizon.net>
>To: tentec@contesting.com
>Sent: Friday, February 27, 2009 1:55:53 PM
>Subject: Re: [TenTec] 041 firmware rev
>
>I have noticed a couple of times after the rig has been on for some
>time, the scope turns all red (signal indicators are still white) and
>then lines start running from top to bottom. First time, I did a master
>reset and it went away. This past time I simply turned off the sweep
>and turned it back on and it was normal again. Anyone experienced this
>yet??
>
>Dennis W5UV
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|