TenTec
[Top] [All Lists]

Re: [TenTec] Orion at QRP levels

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion at QRP levels
From: "jack" <jfriend31@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 3 Feb 2009 20:24:19 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
i have had good reports on CW using the Orion turned down to 5 watts or 
less. no indication of any negative sort in that mode.
jack ak7o

----- Original Message ----- 
From: "Ralph Matheny" <mathenyr@marietta.edu>
To: <tentec@contesting.com>
Sent: Tuesday, February 03, 2009 7:06 PM
Subject: [TenTec] Orion at QRP levels


> This past weekend I wanted to make a few Q's in the QRP SSB contest, so
> I cranked down the Orion to 5 Watts and called away.  In a few minutes,
> I received what I believe was an accurate report that the signal was
> broad and producing "splatter".  After giving some thought, it seems
> obvious that resetting the mike gain, speech proc, etc. are probably
> needed in order to use the Orion at low power levels. I also suspect that
> the 100-watt amp could be both a good 100-watter and a 5-watter without
> bias adjustment, at least for SSB.
>
> Does anybody else use the Orion at QRP??  Problems or results?
>
> Ralph Matheny
> K8RYU
> 207 Gibbons Place
> Marietta Ohio  45750
> mathenyr@marietta.edu
>
>
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>