Dell,
Thank you for taking the time to send the setup information. However, it
still does not communicate. I did a master reset of the Omni with no change?
I have a couple of additional questions. The PCI serial card has two DB9
female connectors on it. Looking at the hardware information on Windows XP
it says they are COM-5 and Com-6. How do I tell which is which? I.E.: is the
cable hooked up to 5 or 6?
In TRX the setup manager (Parameters) on the right side there is a TRX Port
1 with a pull down box with all of the possible Com 5,6 etc connections.
Below this is another pull down box with Com 5, 6 etc. Which one is for the
communication port the cable is hooked up to my computer? What is the other
one for?
Thank you again for your help.
Best,
DW Holtman
WB7SSN
----- Original Message -----
From: "Dell Ray" <ray_2098@yahoo.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, January 26, 2009 8:09 PM
Subject: Re: [TenTec] Ham Radio Deluxe
> Hi Dyke
> I don't remember If you have a manual, And if you checked the settings
> according to the manual. When I ran TRX the first time The only thing i
> had to do was select the rig then pick my baud rate and comm port.
> Everthing else I left as default. I have Addr.=04, Ctrl=E0, mem=90,
> Stop bits=2, TRX Port1=Com 4, CAT speed=19200, dual control=checked,
> RTS Enable=checked, DTR enabled=checked, PTT=CAT, TX Interrupt=DSR,.
> I use a over the counter Belkin cable from computer to rig. I am using
> vista 64 on a duel Intel CPU. I also had to buy a serial card but mine was
> a Rosewell. Just be sure the rig is the same settings as Comp.
> Also you might try a master rest of the Rig. Might have a brain cramp.
>
>
> Dell R Smith
> Prosser,Wa
> KI7XD DN-06
> OMNI VI Opt1
>
>
> --- On Mon, 1/26/09, DW Holtman <tubestuff@comcast.net> wrote:
>
>> From: DW Holtman <tubestuff@comcast.net>
>> Subject: Re: [TenTec] Ham Radio Deluxe
>> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
>> Date: Monday, January 26, 2009, 6:40 PM
>> Hello,
>>
>> I installed a PCI serial card from byterunner. Windows
>> under XT under
>> Hardware information, tells me that it is properly
>> installed and working. I
>> triple checked the wiring in the cable. Tried Hyperterminal
>> as suggested in
>> the Ten Tec troubleshooting document. Not too sure that I
>> had Hyperterminal
>> was set up correctly? Still no luck, no communication. I
>> tried two software
>> packages, HRD and TRX.
>>
>> Any suggestions on where I should go from here?
>>
>> Thank you,
>> DW Holtman
>> WB7SSN
>>
>> ----- Original Message -----
>> From: "Mike, K9UW" <k9uw@wi-net.com>
>> To: "Discussion of Ten-Tec Equipment"
>> <tentec@contesting.com>
>> Sent: Sunday, January 18, 2009 6:05 PM
>> Subject: Re: [TenTec] Ham Radio Deluxe
>>
>>
>> > DW, I've used PCI serial cards from Byterunner on
>> several occasions with
>> > excellent results. They're cheaper than most
>> places as well. Their
>> > telephone rep told me, last time I called, that Hams
>> were regular
>> > customers.
>> >
>> >
>> <http://www.byterunner.com/byterunner/category=2+Serial+(RS-232)+PCI-bus+cards/exact_match=exact>
>> >
>> >
>> > 73, de Mike, K9UW
>> > Amherst, WI
>> >
>> > DW Holtman wrote:
>> >> Tim,
>> >>
>> >> I will check tomorrow and see if I can find a
>> Serial Port PCI Card. Is
>> >> there any drivers etc required, or is a Serial
>> Card plug and go.
>> >>
>> >> Thank you again,
>> >> DW Holtman
>> >> WB7SSN
>> >>
>> >>
>> >>
>> > _______________________________________________
>> > TenTec mailing list
>> > TenTec@contesting.com
>> > http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|