Hi,
Go to control panel, select system, then device manager. The ports will be
listed there along with the port numbers.
73
Tim
gm4lmh
----- Original Message -----
From: "DW Holtman" <tubestuff@comcast.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, January 18, 2009 2:42 PM
Subject: Re: [TenTec] Ham Radio Deluxe
> Hello,
>
> Thank you to everyone who send suggestions and ideas to fix this problem,
> especially Dell KI7XD for sending me a three page document from Ten Tec.
> However, the problem is the same. I'm using a 25 db to 25 db cable. It is
> wired correctly according to the manual and the document from Ten Tec. The
> only difference is the manual has some jumper wires on the PC side of the
> plug. The document does not show the jumpers? What are they for? It is
> wired:
>
> 2 to 2
> 3 to 3
> 7 to 7
>
> and jumpers on the PC end
>
> 4 to 5
> 6 to 8 to 20.
>
> The document talks a built in diagnostic mode to trouble shoot
> communication
> problems. It is several years old making references to Windows 98 and
> using
> HyperTerminal to communicate. I will try this out I'm running XP.
>
> My computer has no 9 pin serial ports. It has one 25 pin serial port on
> the
> back (I assume it is serial port). How can I figure out if it is com 1 or
> com 2 etc?
>
> Any more help or suggestions would be greatly appreciated. I hope this
> makes
> some sense, there are several items mentioned.
>
> Best,
> DW Holtman
> WB7SSN
>
>
>
> ----- Original Message -----
> From: "DW Holtman" <tubestuff@comcast.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Friday, January 16, 2009 3:56 PM
> Subject: [TenTec] Ham Radio Deluxe
>
>
>> Hello,
>>
>> I recently aquired a Omni VI Plus and I wanted to know if anyone uses Ham
>> Radio Deluxe with it. I cannot get it to communicate with my computer. I
>> first tried using a DB-25 (Radio) to a DB 9 through a Belkin serial to
>> USB
>> adapter, no luck. Next I wired a DB-25 to DB-25 thinking this set up did
>> not
>> like the Balkin. Still no luck. I told HRD that I have a IC-735 as per
>> the
>> manual.
>>
>> Any ideas? Thank you in advance.
>>
>> Best,
>> DW Holtman
>> WB7SSN
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|