Mike,
Thanks again, it is non amplified.
Best,
DW Holtman
----- Original Message -----
From: "Michael Brown" <k9mi@sbcglobal.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, December 29, 2008 6:02 PM
Subject: Re: [TenTec] Mic for Ten Tec Omni 6 Plus
> Just put a 4 pin mic plug on it and you're in business. Non-amplified
> would
> be best, but if it is amplified, you probably would just need to have the
> gain barely cracked open.
>
> 73, Mike K9MI
>
>
> ----- Original Message -----
> From: "DW Holtman" <tubestuff@comcast.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Monday, December 29, 2008 14:33
> Subject: Re: [TenTec] Mic for Ten Tec Omni 6 Plus
>
>
>>
>> Hello,
>>
>> I have a nice working Astatic D-104 mic. If correctly wired, how would it
>> work on a Omni 6 Plus? Would an audio interface be required?
>>
>> Thank you,
>> DW Holtman
>> WB7SSN
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|