Also, make sure your computer is putting out sufficient audio from the line
out connector. That can be adjusted within Windows. Make sure all your
cables are good (I got stung with a bad cable last week and thought it was
something in the Orion!) and that there are no attenuators in the system
that you didn't know about.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "Wayne Whitman" <wwhitman@fastmail.fm>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, December 27, 2008 8:24 AM
Subject: Re: [TenTec] PSK 31 with the Orion II
> Ed - make sure the power is set to 100w, then control the power out with
> the audio drive.
>
>>From what you said, I'm assuming you have the audio input in the menu
> set to AUX or BOTH.
> You might try running the aux gain up all the way to see if you get
> anything in.
>
> 73,
> Wayne
> K4ELO
> k4elo@fastmail.fm
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|