Yes, there are separate volume sliders for each receiver. And the
headphones are automatically set to have a different receiver is each ear
when you turn on dual receive and then switch back to the main receiver in
both ears when you turn dual receive off.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Tom Berry" <tberry1@triad.rr.com>
To: "N4PY" <n4py@arrl.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Saturday, December 20, 2008 4:25 PM
Subject: Re: [TenTec] Lone voice in the wind
>
>
>> My N4PY Orion software has can be operated in diversity mode. And my
>> program has an adjustment in it to allow for a slight frequency offset in
>> the 2 receivers and correct it.
>>
>
> That sounds great Carl, Does it have the ability to adjust the volume of
> both receivers at the same time.
> If not that would be a good enhancement in my humble opinioin.
>
> Thanks
> Tom AA4VV
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|