I had a similar problem and found that by turning the pass band knob
slightly it would go away. usually showed up on power on.
73, john
kc0yai
----- Original Message -----
From: <atrampler@att.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, December 07, 2008 7:20 AM
Subject: [TenTec] Omni VI Opt 3 Audio Problem
Intermittently I lose most of my RX volume, both from the speaker/headphone
jacks and the line out.
Sometimes turning the rig on and off will cure the problem.
In short, I have audio, but very low, and the volume controle does nothing
till wide open, and then I have only white noise.
I believe it is in the DSP board or a relay to it, because I totally lose
sidetone, spot tone, and features such as the automatic notch filter and DSP
audio filters. The manual notch filter still works.
Anybody experience this and have a suggestion?
Art, KØRO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|