Ron,
I don't remember it being 1:2 last year but it could be insidious and
crept up on me. Guess I need to break out the old tel-Ohm-Mike & see
what they show.
Gary
KA1J
> Gary: The low-pass filter is a fixed, pi network, so it can't be
> adjusted. My guess is that one of the capacitors, C7, C8, C9 or C10
> has changed value or opened up. C7 and C10 are 1500 pf, and I would
> be most suspicious of those two since they are the largest value.
>
> Ron N6IE
> www.N6IE.com
>
>
> ----- Original Message -----
> From: "Gary Smith" <Gary@doctorgary.net>
> To: <TenTec@contesting.com>
> Sent: Wednesday, November 19, 2008 8:36 PM
> Subject: [TenTec] Titan 425 tuned input
>
>
> > Any easy way of adjusting the tuned input of my 425? My Omni shows a
> > 1:2 swr on 80M when running the amp. With the amp in standby as the
> > well as off, the Omni shows a 1:1 to the antenna. The SWR meter on
> > the Titan shows 1:1 under power.
> >
> > So it seems as if the 80M input might need to be polished up a bit.
> >
> > Suggestions?
> >
> > Thanks
> >
> > Gary
> > KA1J
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|