Tom,
I had problems like that also for along time, usually happened when I apporched
200+ watts output.. Ended up replacing pass transistors in 1 9420 ps unit..
Than found a bad solder joint on one of the big shunt resistors on the power
dist board.. Start at the power connector and work to the amp boards checking
voltages at each one.. Do a little tug and wiggle on "EVERY" component lead you
can get at.. If it moves look again.. I ended up replaceing all 8 power
transistors and found 5 more bad solder joints..
The HERC II is worth anything it takes to fix..
GL,
Harry Coates
WA8HC1@charter.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|