Scott,
I'm running an ORION I that I bought from you guys at last year's Ten-Tec
hamfest. I'm using a 30 years old Shure 444 type microphone, but I plan to get
something much better when I can decide what. I use no external processing. I
never use the built-in processing because it sounds bad to me at any useful
setting. I have the TX EQ set to -15 dB to keep the 444 from sounding too
muddy.
I love the receiver and CW operation aspects of the ORION. I surely wish I
had had it at S9SS, especially for 160M CW.
I enjoyed the '08 hamfest and my second tour of the factory. SEDCO was fun
also.
73,
Charles Lewis - KY4P
ex S9SS, SV0LM, S92SS, A22AA, etc.
(Now very happily retired in the NC mountains in Ashe County after 19 years
overseas with VOA)
----- Original Message ----
From: Ten-Tec Amateur Radio Sales <sales@tentec.com>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Thursday, October 9, 2008 9:34:00 AM
Subject: [TenTec] SSB operators Omni-VII, Jupiter, Orion's
Good morning,
Iʼm working on a small project here at Ten-Tec that I could use a little
user feedback on via email.
If you currently use a Jupiter, Omni-VII, Orion or Orion II as your main
HF transceiver and either most of the time or exclusively operate SSB on
HF and would like to help out by answering a short survey via email,
drop me an email at sales@tentec.com Tell me what rig youʼre running,
what microphone(s) you use and if you are using external audio
processing gear between the microphone and the input of the rig,
describe that as well. Iʼll respond with a survey of a few questions,
and then I might follow it up with another email with additional
questions based on the answers to the first email.
Thanks in advance,
Scott Robbins, W4PA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|