Mark,
I have been using my Centaur on AM for some time without problems. Keep in
mind that the PEP output in 100% modulated AM is 4 times the carrier output.
I belief a safe level is to keep the power no higher than 1/4 the RTTY
rating. Not sure where that hits the Centurion specs, but it should be quite
conservative and going to 1/2 the RTTY spec is likely OK, if you watch the
transmit time -- AMers tend to talk longer than RTTYers type, in my
experience <g>.
The other factor, is to keep the carrier output below 375 W to be within FCC
1500 W PEP rules.
Regards, Joel
Joel R. Hallas, W1ZR
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Mark DeBord
Sent: Sunday, October 05, 2008 12:13 PM
To: tentec@contesting.com
Subject: [TenTec] Operating AM with the Centurion amplifier
I am using the Orion II and the Centurion amplifier. I enjoy operating AM on
occasion with this set-up. I load the amp at full output (using CW), but
then reduce my drive on the rig to only produce total carrier output of the
amp to about 150 watts.
Can I increase my rig's drive to produce more from the amp without a concern
(like 250 watts or so)? How long should I limit my keydown times? Do I need
to add additional cooling with an external fan sitting on top or something
like that? Any suggestions is appreciated.
I found a DX-60B at this year's Ten-Tec hamfest and plan on playing with it
driving the amp too.
Any suggestions is much appreciated.
Mark KA4ICK
_________________________________________________________________
See how Windows Mobile brings your life together-at home, work, or on the
go.
http://clk.atdmt.com/MRT/go/msnnkwxp1020093182mrt/direct/01/
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|