I would make sure that TXEN and TXOUT are not reversed. Other than that, it
sounds like you have a fault in the amp.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Paul DeWitte" <kb9lie@gmail.com>
To: <tentec@contesting.com>
Sent: Saturday, September 13, 2008 12:16 PM
Subject: [TenTec] Jupiter/Centurion hook up
>I am trying to hook up Peg's Jupiter to my Centurion amp.It is connected
> like the book shows.
>
> I have the keying loop turned on. It will key the rig if the amp is turned
> off, but will not key the rig if the amp is turned on. It will not key the
> rig either in standby or operate when it is turned on. Turn the amp off
> and
> it will key the rig.
>
> When the amp is turned on in operate, it will key the amp, but the amp
> does
> not key the rig. The key is plugged into the Jupiter.
>
> Have I missed something? Maybe a bad patch cord? But if that is so then
> why
> does it work with the amp turned off?
>
> Thanks for any replies.
>
> 73 Paul K9OT
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|