If you don't get an equivalent part number, measure the old fan
dimensions, (square?), thickness, count the number of fan blades, and
usually you should see a marking on the label of the voltage and current
rating. If you go to the Mouser catalog, you should be able to match
the old fan to one of the current fans. Pick a good ball bearing or
better model for lower noise and longer lifetime. If you match the
current drain, voltage, and number of blades, you should be close to
moving the same amount of air as the original fan.
Stuart Rohre
K5KVH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|