Thanks, Mike. If this is not an old, not-updated post, I was lied to at
Dayton. I was shown a prototype board and was told it was ready for
production. In fact, I was told that the week after Dayton they would
be having a production meeting and that the board would be ready for
general sales within three months or so. A friend of mine who bought an
ORION II about three years ago was told at that time that the board
would be ready "in a few months." He's ready to ditch his Ten-Ten
equipment he is so mad about this issue. When I gave him the
information from Dayton, including my live sitting of the prototype
board, he calmed down a little and said he'd give Ten-Tec a few more
months. In short, I hope what I was told at Dayton is more accurate
than this link. Perhaps, at this juncture Ten-Tec's recent "sins" are
no more than not updating a web page! :-)
Mike Christiansen wrote:
> Check this link at the Tentec site. it should answer your questions
>
> http://radio.tentec.com/status/
>
>
> On Aug 17, 2008, at 4:19 PM, Carl J. Denbow wrote:
>
>
>> Does anyone know the status the new display board that is coming out
>> for
>> the OMNI VII and ORION II? I saw a prototype at Dayton and was
>> assured
>> that it was ready for production. This board will allow, among other
>> things, for real time, continuous spectrum scope (like the ICOM 756
>> pro
>> series has). I'm really looking forward to this new board, which is
>> supposed to cost in the $300.00 range.
>>
>> Carl
>> N8VZ
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|