Hi Tim,
Figure 4-18 Control Board Schematic (81596) on page 4-31 and the third
paragraph in the narrative description of that board on page 4-29,
should tell you everything you need to know.
To paraphrase what the manual says, the TX OUT is pulled to ground by
Q11, which is a MPS 6514, when the Omni VI wants to transmit. If the QSK
circuit in your amplifier will pull the TX EN line to ground when it is
ready for drive, the Omni will oblige.
DE N6KB
Tim Randa wrote:
> Can someone clue me in on the operation of the tx-in and tx-out jacks on
> the back of the Omni VI+? I hope to use the radio with a modified
> ALS-600 amp that has the QSK mod board installed and wonder what kind of
> interface will be needed from the out/in jacks to keep the radio safe.
> Any suggestions would be appreciated.
>
> 73 de Tim KØFL
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|