Does the A/B button work Ok instead of REV?
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Dennis Doran" <wb8wtu@gmail.com>
To: <tentec@contesting.com>; "Dennis Doran" <wb8wtu@gmail.com>
Sent: Wednesday, July 16, 2008 10:11 PM
Subject: [TenTec] Delta II Question
> Hello all,
>
> Are there any current owners of a Delta II (or Argonaut II) on the list ?
> I
> have a question regarding the operation of the "REV" function when
> operating
> split. On my unit, when operating split, if I switch between VFO A and VFO
> B
> (on the same band) all sounds normal. But if I press the REV button to
> monitor the opposite VFO, the frequency is displayed correctly but the
> audio
> is 700 Hz too low. In other words, you cannot hear the other station on
> the
> other VFO. I must hold the REV button and tune up 700 Hz to hear the
> signal.
> Then when I switch between VFO and VFO B, the second VFO is now 700 Hz too
> high.
>
> So, by using the REV function, the control circuitry is not adding the 700
> Hz offset. Before I dig deeper looking for a problem, I'm asking if
> another
> Delta II owner can confirm that their unit operates differently than mine.
> Thanks in advance.
>
> dennis
> wb8wtu
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|