TenTec
[Top] [All Lists]

[TenTec] interface to Mark 5

To: <n4py@arrl.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: [TenTec] interface to Mark 5
From: Charles Harpole <k4vud@hotmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 16 Jul 2008 01:40:03 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
As a former owner of two Mark 5 Yaesu rigs, I can warn about using the

Class A switch and other adjustments that run it at less than full RF output.

Mine failed in Class A at 40 watts driving an amp.  Vy smart folks have not

yet found the problem.  The other rig, I am told, also had an RF deck 

failure but I do not know if that was due to intentional reduced output.

My ORION ONE seems to do ok at lowered output.  73


Charles Harpole

k4vud@hotmail.com






> From: n4py@arrl.net
> To: tentec@contesting.com
> Date: Mon, 14 Jul 2008 19:32:36 -0400
> Subject: Re: [TenTec] TenTec 1208
>
> The bypass switch on the transverter was designed for 100 watts. I believe
> you are ok at 200 watts doing this but I would watch the SWR at the rig. If
> it suddenly jumps then it was not ok.
>
> Carl Moreschi N4PY
> 121 Little Bell Drive
> Bell Mountain
> Hays, NC 28635
> ----- Original Message -----
> From: "AD5VJ Bob" 
> To: 
> Sent: Monday, July 14, 2008 6:17 PM
> Subject: [TenTec] TenTec 1208
>
>
>>I just acquired a TenTec 1208 to use with my FT-1000MP MKV and I have a
>>couple of questions.
>>
>> I know that I have to detune the rig to 5-7 watts to use the 1208
>>
>> My main question is:
>>
>> If I hook up to the 'HF' antenna port and switch over to 'bypass' can I
>> still use my 200W output into the bypass of the inverter, or
>> do I need to put a coax switch inline and completely bypass the inverter?
>>
>> My next question is does anyone have a 6 meter vertical they would part
>> with?
>>
>>
>> 73 fer nw es gud DX,
>> QSL VIA: LotW, BUR, e-QSL
>> Bob AD5VJ
>> http://www.ad5vj.com/
>> Old Calls WB5ZQU, WY5L/KH3, KE5CTY, N5IET
>>
>> Luke 14:28-30
>>
>> 28"Suppose one of you wants to build a tower. Will he not first sit down
>> and estimate the cost to see if he has enough money to
>> complete it? 29For if he lays the foundation and is not able to finish it,
>> everyone who sees it will ridicule him, 30saying, 'This
>> fellow began to build and was not able to finish.'
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>