If the LP filter is actually needed Jerry's one-foot spacing should be an
absolute maximum.....As short as possible.
And to expand, the high-pass filter on a TV should be very close to the
tuner itself. One inch often is far too much.
----- Original Message -----
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
To: "Edward Sylvester" <navydude1962@yahoo.com>
Cc: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, May 18, 2008 3:20 PM
Subject: Re: [TenTec] Low Pass Filter
> On Sun, 2008-05-18 at 10:55 -0700, Edward Sylvester wrote:
>> So, Jerry, just have it at the output of the amp??
>
> Yes and as close to the amp as possible, not with a few feet or more of
> coax between the amp and the filter. Keep that coax jumper under a foot.
>
> The PA running class B makes lots of harmonics even when driven with a
> perfectly clean signal, so the intermediate filter will just upset the
> impedance match between the exciter and the PA.
>
> 73, Jerry, K0CQ
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|