John wrote:
> Hello I was on the air today with my Orion II and I was getting some
> interference from a nearby station I tighten up the band pass filter and
> started playing with the PBT and hi - lo cut . I realized that I still don't
> understand the operation of these controls to move the offending stations or
> move away from this station. I fiddled with these controls and was unable to
> remove the offending station the controls seemed to do very little if
> anything . Is there a good explanation of how to use these controls some
> where . One question , do I have to have the pbt light on before I attempt
> to use the H or L cut feature ? Thanks John kb2huk
>
>
Hello John,
Take a look at http://www.tentecwiki.org/doku.php?id=566
Scott W4PA, wrote an excellent article on the Hi-Low cut settings.
'73 Mark, PA5MW
pa5mw.blogspot.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|